Alpha Group OutBack Power MATE3, Owner'S Manual

Page: 33 / 160

Operation
900-0117-01-00 Rev A
31
If a FLEXnet DC battery monitor is present on the system, the
Battery
soft key brings up the following
screens.
Figure 14 Battery Soft Key Screens (with a FLEXnet DC Monitor)
Battery Soft Key
Press this soft key to
view Battery Status
information.
Home Screen
Screen Items:
The upper left corner of the screen shows the
uncompensated battery voltage.
The upper right corner shows the measured
State-of-Charge (SOC).
In
displays the measured total current and
kilowatts coming into the system from all DC
sources. To the right, this line displays the
total amp-hours and kilowatt-hours
delivered from all sources that day.
Out
displays the measured total current and
kilowatts being taken out of the batteries for
inverting, DC loads or any other uses. To the
right, this line displays the total amp-hours
and kilowatt-hours removed from the
batteries that day.
Bat
displays the net total current and
kilowatts being sent to or taken from the
batteries. To the right, this line displays the
net total amp-hours and kilowatt-hours
accumulated or taken from the batteries that
day.
The last line shows both the highest and
lowest recorded battery SOC for that day,
and the time each was recorded.
The lower right corner shows the current
status of the battery monitor’s Auxiliary relay
(also known as AUX mode or Relay mode).
(See page 108.)
Soft Keys:
< Next> brings up a series of screens that
show more detailed information on the
battery and on individual shunts used with
the battery monitor. These screens are
shown beginning on page 31.
< Graph> brings up a series of screens that
plot various battery information over time.
The graphs include voltage, SOC, and shunt
information. These screens are shown
beginning on page 34.
< Back > returns to the previous screen.