Old Cod.Q00A00142
OWNER'S MANUAL OF THE MULCH CULTIVATOR PF-PD
New Cod. MANT2010/00493 R.1
ADJUSTMENTS
- 30
Copyright ©2009 della Alpego spa® - All rights are reserved. Reprinting or unauthorized use of this manual is strictly forbidden without written permission by Alpego spa
7.8. CHANGING THE COULTER (WORKSHOP WORK)
Danger of injury or death from unintentional lowering of the raised implements. Mount the locking
device against unintentional lowering of the coulter
CAUTION
Take special care when changing coulters. Do not turn the screws on the square shaft. Risk of injury from
sharp edges
7.9. TYRES/WHEELS
•
Check chassis wheels regularly for damage and firm seating on the wheel rim.
•
There must be a minimum gap of at least 25 mm between the scraper and the running gear tyres.
•
Required tyre pressure.
-
Running gear/roller tyres: 4.3 bar
-
Feeler/support wheels: 1.8 bar
•
Required tightening torque for wheel nuts or bolts:
-
Roller wheels: 350 Nm
-
Support wheels: 250 Nm
•
Regularly check
-
that wheel nuts are firmly seated.
-
tyre pressures.
•
Only use the tyres and wheels which we have specified..Repair work on tyres must only be carried out by
specialists using suitable assembly tools.
•
Tyre fitting requires sufficient skills and proper assembly tools.
•
Use the jack only at the jacking points indicated.
Figure 7-11
Left conveyer
Central tip
Left fin
Right fin
Right
conveyer