All
SportSystems, Inc.
©
2021
Step 1 - Attach Cable to Turnbuckle
Follow the steps below to attach one end of the cable to eye of turnbuckle:
Step 2 - Add eye and trim cable to proper length
Page 23 of 25
Last Revised 12-18-2020
(1)
If the end is frayed or unraveled, tape cable
as shown with electrical tape.
(2)
Cut the cable at the tape so that the cable
end is properly seized and will not unravel.
(3)
Place two wire clips on cable.
(4)
Thread cable end through the eye fitting of
Turnbuckle
(5)
Thread end of the cable back through wire
clips.
(6)
Close loop and tighten wire clips with wrench
so that cable does not slip. Leave about 1” of
cable beyond last wire clip.
