Page 7 of 14
If required, the tool can be returned to the manufacturer, Allspeeds Ltd, for servicing and
testing.
If servicing is to be undertaken by the user, please see note on proof testing under
SAFETY (Chapter 1), and the following:-
All servicing operations should be carried out in a clean environment to prevent contamination
of the oil and mating components.
Care should be taken with all mating areas ie. threads and sealing faces, as any damage or
abrasive contamination could cause galling or seizing on re-assembly.
The cylinder is a pressure vessel and should not be drilled, machined, mutilated or damaged in
any way for mounting purposes or to assist in its removal for servicing, any warranty could be
invalidated by such actions.
The use of stilsons to remove the cylinder is not recommended as damage will occur.
IMPORTANT: Please note this tool is designed for intermittent subsea use. Please refer to the
manufacturer should you wish to use this tool subsea for any period over 14 days.
7.
REPLACEMENT OF THE ANVIL
Remove the two Sliding Block Screws, Washers and Sliding Blocks 035082, 080956 and 709047
The Anvil SSC6475 can now be removed attached to the Anvil Bracket 765174, knock out the
Slotted Spring Pin 030820 this will disconnect the Anvil Bracket and free the Anvil
Re assembly is the reverse of the above.