page 2 of 5
v1
®
®
Installation Instructions
Rubber Washer
PrimaLine Neon Tape Light
Metal Clamp
Metal Sleeve
Plastic Cover
Silicone Insert
1. Cut the tape light to the desired length using the black indicator that can be seen on the side of the tape light
through the silicone casing. We recommend using a Multi-Angle Miter Hand Shear for a clean and precise cut.
NOTE: Dark indicator can be seen through the silicone casing.
NOTE: Avoid twisting or any harsh movement that may damage
the internal components.
1. Connect the tape light to power using the DIY connectors. To
assemble the DIY connector:
a) Slide the rubber washer onto the prongs of the connector. Make sure to
align the rubber washer so it sits against the plastic protrusion on the
connector, without a gap.
b) Thread the plastic cover onto the PrimaLine Neon Tape Light where
the tape light will connect to power. Make sure that the grooves on the
inside the plastic cover are aligned with the indentations on the sides
of the tape light. (Continued on next page)
NOTE: The images on pages 2-5 show PrimaLine Neon 100 SB. For PrimaLine Neon 200 TB, follow the same instructions, but
note that the tape light PCB inside of the silicone is rotated 90°, with the diodes pointed toward the diffuser.
Notches
Indentations
LED
IP65
CUTTING TAPE LIGHT
USING DIY CONNECTORS AND END CAPS
Cut on Black Indicator
Silicone Insert
Specifications subject to change without notice.
www.AlloyLED.com | Call: 800.910.LEDS [5337] | Text: 510.400.6690 | [email protected]
