Allnet ALL1682504, Quick Installation

Page: 3 / 12

© 2015 ALLNET GmbH Computersysteme - All rights reserved Page 3
Errors and omissions excepted
I
MPORTANT
S
AFETY
I
NSTRUCTIONS
This product is intended for connection to the AC power line. For installation instructions, refer to the
Installation section. For removing the device, refer to the Unplug section. The following precautions should
be taken when using this product.

Please read all instructions before installing and operating this product.

Please keep all instructions for later reference.

Please follow all warnings and instructions marked on the product.

Unplug the AC coupler from the wall outlet before cleaning. Use a damp cloth for cleaning. DO
NOT use liquid cleaners or aerosol cleaners
.

DO NOT operate this product near water.

This product should never be placed near or over a radiator, or heat register.

This product relies on the building’s electrical installation for short-circuit (over current) protection.

Ensure that a fuse or circuit breaker no larger than 120 VAC 20A or 240 VAC 16A is used on the phase
conductors (all current-carrying conductors).

DO NOT allow anything to rest on the product interconnect cords. DO NOT locate this product where
people may walk on the cords.

Because the 500Mbps PLC Ethernet Bridge product sends data over the powerline, it is recommended
that you plug directly into a power outlet. Do not plug the device into a UPS or power strip with surge
protection. The 500Mbps PLC-Ethernet Bridge product has its own power filter for protection against
surges.

The product can be operated at an ambient temperature of 40
℃
.

For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily
accessible.

Only a qualified technician should service this product. Opening or removing covers may result in
exposure to dangerous voltage points or other risks.

Unplug the AC coupler from the wall outlet and refer the product to qualified service personnel for the
following conditions:

When the interconnect cords are damaged or frayed.

If liquid has been spilled into the product.

If the product has been exposed to rain or water.

If the product does not operate normally when the operating instructions are followed.

If the product exhibits a distinct change in performance.
I
MPORTANT
S
AFETY
I
NSTRUCTIONS