ALL02860ND Quick Installtion Guide
© ALLNET GmbH München 2013 - Alle Rechte vorbehalten
Package content
Please verify contents of the box before continuing to set up the ALL02860ND.
ALL02860ND Access Point
12V/2A 100V~240V Power Adaptor
RJ-45 Ethernet Cable
Mounting Bracket
Wall/Ceiling Mounting Hardware Kit
T-Rail Mounting Hardware Kit
CD with User's Manual
Please use only the power supply unit that is delivered with the device.
Connecting the ALL02860ND
1)
Ensure that the computer in use has an Ethernet Card (RJ-45 Ethernet Port). For more
information, verify with User Manual.
2)
Connect one end of the Category 5e Ethernet cable into RJ-45 port of the ALL02860ND and
the other end to the RJ-45 port on the computer that will use the ALL02860ND. Ensure that
the cable is securely connected to both the ALL02860ND and the Computer.
3)
Connect the Power DC Inlet to the
DC-IN
port of the ALL02860ND and the Power to the
electrical out.
Please use only the supplied power adapter!
Note
: ALL02860ND supports both IEEE 802.3at PoE(Power over Ethernet) and regular power adapter.
You should use either one as the power source. Please do not apply both at the same time.
IP address configuration
1)
After ensuring the EnGenius device is powered on and plugged in, ensure that your computer
is on.
2)
For the next steps, refer to your Operating System User Manual.
3)
Once your computer is on, ensure that your TCP/IP is set to
On
or
Enabled
. (In the control
panel, double click Network Connections and then double click on the connection of your
Network Interface Card (NIC). Select
Internet Protocol (TCP/IP)
and then click on the
Properties
button.)
4)
If your PC is already on a computer network, ensure that you have set it to a Static IP Address
on the interface (or Ethernet card that will use the ALL02860ND) as
192.168.1.21
and the
