Allnet ALL0258N, User Manual

Page: 33 / 84

Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see
section 4.1).
1. Clicking Accept does not apply the changes. To apply them, use Status > Save/Load (see
section 4.1).
2.
The Access Point to which you want to extend wireless connectivity
must enter the ALL0258N
’s MAC address into its configuration. For more information, refer to
the documentation for the Access Point. Not all Access Point supports this feature.
8.1.4 Client Router Mode
In Client Router Mode, you can access the Internet wirelessly with the support of a WISP. In AP
Router Mode, the ALL0258N can access the Internet via a cable or DSL modem. In this mode,
the ALL0258N can be configured to turn off the wireless network name (SSID) broadcast, so that
only stations that have the SSID can be connected. The ALL0258N also provides wireless LAN
64/128/152-bit WEP encryption security, WPA/WPA2, and WPA-PSK/WPA2-PSK authentication,
as well as TKIP/AES encryption security. It also supports VPN pass-through for sensitive data
secure transmission.
The following figure shows an example of an ALL0258N communicating with a Wireless ISP
(WISP) Access Point in Client Router Mode. The sections that follow the figure below describe
how to configure your ALL0258N for Client Router Mode.
Wireless Mode Wireless mode supports 802.11b/g/n mixed modes.
Channel HT Mode The default channel bandwidth is 40 MHz. The larger the channel,
the better the transmission quality and speed.
Extension Channel Select upper or lower channel. Your selection may affect the Auto
channel function.
Channel / Frequency Select the channel and frequency appropriate for your country’s
regulation.
Accept / Cancel Click Accept to confirm the changes or Cancel to cancel and
return previous settings.