Not for
Reproduction
Operation
Preparing The Port-A-Lite For Use
WARNING
Unsafe Operation Hazard.
Operating the unit with worn, damaged or missing parts can
result in death or serious injury. Always replace worn,
damaged or missing parts promptly. Do not operate this unit
until all worn, damaged or missing parts have been replaced,
and proper operation of unit has been verified.
NOTICE
We encourage the use of authorized Allmand replacement
parts. The warranty does not cover damage or performance
problems caused by the use of parts that are not authorized
replacement parts.
1.
Check that a copy of the Operators Manual is with the unit.
2.
Check that all safety decals are legible and in place on the
unit. See
Safety Decals in the Safety section of this
manual.
3.
Check the unit for proper operation. (See
Operating The
Port-A-Lite for detailed information on operating
procedures.)
• Check that the mast winch operates properly, and that
the inner mast extends and retracts properly.
• Check that the lamp glass lenses are not cracked or
broken, and that it is a frosted lens.
• Check that the power cords, lamp cables and lamp
fixture cords are not frayed or damaged, and that the
power plugs and lamp cable connectors are not
damaged.
• Check that the mast socket knob securing the outer
mast to the base assembly is tightened.
• Check that the light bar knob is tightened.
• Check that the handle nuts securing the lamps to the
base assembly are tightened.
• Check the condition of the wheels and casters, and that
they roll freely.
4.
Connect the lamp cords to the lamp fixture cords. Plug the
power cords into a wall socket. See
Specifications for
detailed information on power requirements.
5.
Turn each power switch to the ON position to check the
bulbs. The bulbs should come to full brightness in 5 to 8
minutes at room temperature. See
Maintenance for detailed
information on replacing bulbs and ballast if the bulbs do
not light. When finished, set the power switches to the OFF
position, disconnect the power cords from the wall outlet
and disconnect the lamp cords from the lamp.
Work Site Considerations
Prior to setting up and operating the work light, the operator
must determine where to place it on the work site. It is the
operator's responsibility to ensure that the work light is properly
and safely positioned on at the work site. Be sure to follow rules
or instructions for your work site, and any state, province and
federal rules that may apply.
Overhead Obstructions
Always keep well clear of any overhead power wires. Make sure
there are no overhead obstructions where you intend to place
the portable work light. Keep clear of any loose cables, ropes
or obstructions that could ensnare the mast or lamp fixture.
When the mast is fully elevated, the portable work light stands
12.0 feet (3.7 m) from ground level to the top of the lamp fixture.
DANGER
Electrocution Hazard.
Contact with overhead electrical wires will result in death or
serious injury. Always follow the rules or instructions for your
work site, and the state, province and federal rules for
maintaining a safe distance from overhead wires.
Wetness & Wind
The portable work light must be placed on a dry surface away
from areas that might become wet.
7
Summary of Contents for PORT-A-LITE PAL 2500W4
