22 ALLMAND.COM
Circuit Breaker
In case overload or short-circuited wire connection
should occur, the circuit-breaker trips.
If tripped, stop the unit, disconnect the load, reset the
circuit breaker, and identify and correct the problem.
To reset the breaker:
Press down on the breaker lever until it clicks.
Thermal Relay
In case an overload or short-circuit should occur to the
load or load connection cable, this relay functions to
trip the circuit-breaker.
It is not necessary to push the reset button even after
the three-phase main breaker is tripped since the
thermal relay is set to automatic return at the factory.
Reset Button
Thermal Relay
Circuit Protector (CP) for AVR Protection
AVR is equipped with circuit-protector (CP) for
protection against overcurrent. It functions in the
following cases:
• The machine gets overloaded while engine speed is
still lower.
• The output voltage of generator is increased higher
than the specified voltage.
When CP functions, voltage drops.
To reset, press the white AVR button (
A
) inside the
control panel.
A
Go
to
Discount-Equipment.com
to
order
your
parts
Summary of Contents for Maxi-Power MP65-8B1
