Copyright © 1998 General Motors Corp.
E–23
W T E C I I E L E C T RO N I C C O N T RO L S T RO U B L E S H O OT I N G M A N UA L
APPENDIX E — CONNECTOR PART NUMBERS, TERMINAL PART
NUMBERS, TOOL PART NUMBERS, AND REPAIR INSTRUCTIONS
1–6.
PACKARD WEATHER PACK CONNECTORS (TPS; 3-WAY RMR SENSOR;
HD RETARDER TEMPERATURE; 6-WAY GILLIG VIM; 4-WAY RMR DEVICE,
TYPE 3; 3-WAY RMR DEVICE (DEDICATED PEDAL))
A.
Connector/Terminal Repairs
B.
Terminal Removal
1. Unlatch and open the secondary lock on the connector (Figure E–4, View A).
2. On the front of the connector, insert remover tool J 38125-10 over the terminal. Push the tool over
the terminal and pull the terminal out of the back end of the connector (Figure E–4, View B).
3. If terminal is to be replaced, cut terminal between core and insulation crimp (this minimizes
wire loss).
NOTE:
Two special tools are available for this operation: tool J 38125-6 (Paragraph C); tool J 35606 or
J 38852 (Paragraph D).
Crimping Tool
Wire Crimp
Insulation Crimp
Alternate Crimping Tool
Remover Tool
J 38125-6
Anvil “2”
Anvil “5”
J 35606 or J 38852
J 38125-10
Use
Description
P/N
Throttle Position
Connector
12015793
Sensor (TPS)
Terminal
12089040
Wire Seal
12015284
RMR Device
Connector
12015795
Terminal
12089040
Wire Seal
12015284
Retarder
Connector
12015792
Temperature
Terminal
12089040
Sensor
Wire Seal
12015284
6-Way Gillig VIM (Towers)
6-Way Plug
Connector Seal
Terminal (Socket)
Wire Seal
Cavity Plug
12015799
12010227
12089188
12015323
12010300
6-Way Gillig VIM (Shrouds)
6-Way Receptacle
Terminal (Pin)
Wire Seal
Cavity Plug
12010975
12089188
12015323
12010300
