Remove Grease fittong from Hammer.
I n s t a l l 4 M S P P s i d e o d I t e m 1
4BSBB/4MJIC adaptor:
5. Install 90 degree elbows on hammer ad-
aptors.
·
Elbow (3), #4JIC, for lubrication con-
nection.
·
Elbow (4), #6JIC, for hydraulic con-
nection.
6. Connect hoses to elbows (refer to Sec-
tion 5.2 for retrofit kit instructions):
·
Hose (5), 3/8-inch, for hydraulic line
connection.
·
Hose (6), 1/4-inch, for lube supply line
connection.
·
7. Connect hoses to AutoLube III pump
with adapters.
·
Adapter (9), #4JIC, for lubrication
connection.
·
Adapter (10), #6JIC, for hydraulic
connection.
8. Bolt AutoLube to Bracket with Hard-
ware provided.
9. Refer to Section 7.1 and install Allied
Chisel Paste cartridge into AutoLube III
cartridge housing. The cartridge can be
refilled and re-used.
6.2 Installing the Reservoir Retainer
The reservoir clip has fingers that fit into a
groove at the lower end of the grease car-
tridge housing. When the retainer is tight-
ened, the housing is pulled into the pump
head. Before installing the Reservoir Re-
tainer, ensure that the Grease Cartridge
A
llied
AutoLube III
10
11/11/02
Connect to Autolube III
pressure port on hammer
port on hammer
Connect to lubrication
8
5
4
2
1
3
6
7
Vent valve
Figure 6-2. AutoLube III Installation