Allied AutoLube II, Technical Manual, Page: 20 / 28

TROUBLESHOOTING (cont’)
7.1 AUTOLUBE II INOPERABLE
If the AutoLube II fails to work properly
and the cause cannot be determined, con-
tact your Allied Technical Service Depart-
ment for further assistance.
7.2 MANUAL LUBRICATION
There are two ways to lubricate the demoli-
tion tool if the AutoLube II is out of service:
·
Lubricate through the lubricating nipple
using a hand-held grease gun.
·
Move lubricating nipple from AutoLube
II to hammer as follows:
1.
Unscrew the lubricant line from the
hammer connection.
2.
Remove lubricating nipple from the
AutoLube II.
3.
Screw lubricating nipple directly into
hammer connection.
4.
Lubricate using a hand-held grease
gun.
A
llied
AutoLube II
16 11/1/03
Problem Cause Remedy
Lubricant Supply too Low. Piston stroke set too short. Adjust piston stroke (refer to
Section 6.5).
Lubricant Supply too High Piston stroke set too long. Adjust piston stroke (refer to
Section 6.5).
Lubricant Supply Incorrect Wrong type of lubricant. Observe lubricant recom-
mendations.