Allied 5500, Technical Manual, Page: 51 / 68

6. Apply anti-seize thread lubricant spar-
ingly to the threads of the End Cap (10)
and the Body/Anvil (1). See Figure
9-35.
7. With the exception of the End Cap (10)
and the Whip Hose (14), coat the Tail
Assembly components with hydraulic
fluid.
8. Insert the Valve (7) into the Striker (2)
and thread the End Cap (10) into the
Body/Anvil (1), as shown in Figure
9-36.
9. Hand tighten the End Cap (10) to the
Body/Anvil (1).
10. Place the Hole-Hog on a level surface.
Holding the Body/Anvil (1) with a strap
wrench, use wrench P/N 835758 to
tighten the End Cap (10), as shown in
Figure 9-37.
11. Tighten the End Cap to a torque of
550- ft.-lbs (745nm). If a torque wrench
is not available, use the following pro-
cedure. See Figure 9-38.
a. After tightening the End Cap hand
tight, put a scribe mark on the End
Cap next to the Body/Anvil.
A
LLIED Model 5500 Hole-Hog
08/25/00 41
Do Not Damage internal threads of the
Body/Anvil while installing the Striker.
Figure 9-34. Insert Striker into the Body/Anvil.
Internal Threads of
the Body/Anvil
External Threads of
the End Cap
Apply Anti-Seize Lubricant to:
Lubricate Valve Components
Figure 9-35. Prepare Body/Anvil and Tail
Assembly.
Body/Anvil Tail Assembly Striker
Insert Valve into Striker Bore
Figure 9-36. Insert Valve into Striker.
Apply Wrench 835758
to End Cap.
Apply Strap Wrench or Saddle
Clamp to Body/Anvil.
Block Body/Anvil to prevent
lateral movement.
Figure 9-37.Secure End Cap to Body/Anvil