Allied 5010, Operator And Parts Manual

Page: 9 / 28

9
Assembly - 5010 & 6010 Snowblower
Assembly Instructions
1. Mount the discharge spout (#2) using the spout clamps (#3) bolted to the spout ring on the
snowblower. Lubricate the spout ring and clamp. NOTE: A hydraulic cylinder and hose kit to
control the spout deflector is available as an option.
2. Hitch Assembly: With right and left hitch tubes (#5 & #6) turned as shown in drawing, slide
them into the sleeves welded to the main body. These tubes are adjustable to four different
positions. The correct position for each individual tractor will be determined when mounting
the snowblower on the tractor. These tubes are connected to the snowblower with a 3/4" x
3-1/4" pin (#11) and a hairpin clip (#12). Bolt the left (#83) and the right (#84) hitch arms to the
outside of the clevises on the hitch tubes using the lift pins (#9).
NOTE: Pins should be turned
to the outside. Do not tighten any hardware until assembly is complete. Join the top of the
hitch arms by bolting a 1" O.D. x 2-1/4" spacer (#4) between the top plates using 3-3/4" x 4" bolt
and lock nut through the lower outside holes. Bolt the hitch top bar (#85) between the same
plates using the same bolt through the welded tube on the bar. Use the inside holes on the
top plates for the top bar. The other end of the hitch top bar bolts to the top of the blower fan
housing with a 1/2" x 1-3/4" hex bolt, lock washer and hex nut. Use the same hole position as
the hitch tubes. Tighten all hardware.
A category 1 top link pin (#8) is fitted in the top holes of the hitch arm plates. This pin is used
for standard three-point hitch only. The bushing in the lower holes is used for the quick hitch.
3. Hand Crank Assembly: (Standard)
- Bolt the crank mounting bracket (#16) to the top of the hitch using 3/8" x 1-1/4" hex bolts,
lock washers and hex nuts.
- Insert the crank tube (#15) through the mount and through the bracket welded to the main
housing. Lock the crank in place using a washer and roll pin on each side of the bracket.
- Thread the cable (#17) through the hole in the crank tube to even lengths and wrap around
the tube to each side of the hole four turns in opposite directions.
- With the spout turned forward, fasten the cable to the bracket welded to the bottom of the
spout using a 1/4" cable clamp (#70).
4. Hydraulic Control Assembly: (Option)
- Bolt the hydraulic swivel assembly (#21) to the back of the fan housing on the left side
using 1/2" x 1-1/4" hex bolts, lock washers and hex nuts.
- Bolt the cylinder mounting bracket (#23) to the back of the fan housing on the right side
using the same size hex bolts.
- Turn the spout forward and the center of the swivel arm in line with the spout center. With
the spout and swivel arm in this position, wrap the cable (#22) around the spout and clamp
to both ends of the swivel arm and to the bracket welded to the bottom of the spout using
3/16" cable clamps (#20).
- Use a standard 8" stroke cylinder (20-1/4" min., 28-1/4" max. pin centers).