x610 Series Layer 3 Gigabit Ethernet Switches Installation Guide
107
AC Power Connection to a Power Supply Module
To power on a switch with an AC Power Supply Module, perform the
following procedure:
1. Position the power cord retaining clip in the up position, as shown in
Figure 74.
100-240V
AC
~
Figure 74. Power Cord Retaining Clip in the Up Position
Note
The AT-PWR1200 power supply does not have a retaining clip.
2. Plug the power cord into the AC power connector on the rear panel of
the unit, as shown in Figure 75. Lower the power cord retaining clip to
secure the power cord to the unit.
Figure 75. Connecting the AC Power Cord
Warning:
Power cord is used as a disconnection device. To de-
energize equipment, disconnect the power cord.
E3
100-240V
AC
~
