Allied Telesis AT-x930-28GPX, Installation Manual

Page: 133 / 214

x930 Series Installation Guide for Virtual Chassis Stacking
133
Installing the Switch on a Concrete Wall
Allied Telesis recommends a minimum of three people for this procedure.
To install the switch on a concrete wall, perform the following procedure:
Caution
The switch is heavy. Always ask for assistance before moving or
lifting the device so as to avoid injuring yourself or damaging the
equipment.
Caution
The switch should be installed on a wall by a qualified building
contractor. Serious injury to yourself or others or damage to the
equipment may result if the switch is not properly secured to the
wall.

E105
1. Place the switch in a table.
2. Install the four brackets with sixteen screws that come with the switch
to the sides of the unit, as shown in Figure 61 on page 130 and Figure
62 on page 131.
3. Have two people hold the switch on the concrete wall at the selected
location for the device while you use a pencil or pen to mark the wall
with the locations of the four screw holes in the four brackets. Refer to
Figure 64 on page 134.
Please follow these guidelines as you position the switch on the wall:

Position the switch so that the front panel faces the left or the right.
Refer to Figure 56 on page 122. You may not install the switch with
the front panel facing up or down.

Leave sufficient space from other devices or walls so that you can
access the front and back panels. Refer to “Recommended
Minimum Wall Area Dimensions” on page 123.