Allied Telesis AT-x930-28GPX, Installation Manual

Page: 131 / 214

x930 Series Installation Guide for Virtual Chassis Stacking
131
The sides of the switch have two sets of holes. One set is for installing
the switch on a wall with the brackets and the other set is for the AT-
RKMT-SL01 Rack Mounting Kit. The holes for the brackets are
identified in Figure 62.
Figure 62. Mounting Holes
3. After attaching the brackets to the side of the switch, have two people
hold the switch on the plywood base on the wall while you secure it
with the four provided screws. Refer to Figure 63 on page 132.
Please follow these guidelines as you position the switch on the wall:

Position the switch so that the front panel faces to the left or the
right. Refer to Figure 56 on page 122. You may not install the
switch with the front panel facing up or down.

Leave sufficient space from other devices or walls so that you can
access the front and back panels. Refer to “Recommended
Minimum Wall Area Dimensions” on page 123.
Wall Bracket
Holes
Wall Bracket
Holes
Front (Left Side)
Wall Bracket
Holes
Wall Bracket
Holes
Front (Right Side)