Installing the Bridging Converter
20
Installing the Bridging Converter
To install an AT-FS232 or AT-FS232/x Series Bridging Converter, perform the
following procedures:
1.
Remove all equipment from the package and store the packaging material
in a safe place.
Note
Do not remove the dust cover from the fiber optic port until you are
ready to connect the fiber optic cable. Dust contamination can adversely
impact the operating performance of the port and the bridging
converter.
2.
Attach the four protective feet (provided) to each corner of the bottom of
the unit, as shown in Figure 9.
Note
Do not attach the protective feet if you are installing the bridging
converter in an AT-MCR12 chassis.
Figure 9
Attaching the Protective Feet
3.
Configure the DIP switches. Refer to Figure 3 or Figure 4 on page 3 for
the location of the DIP switches and Table 6 on page 21 for the possible
settings.
Note
A change to the DIP switch setting does not take effect until after you
reset the unit. To reset the unit, power the unit OFF then ON.
