Allied Telesis AT-FAN08, Installation Manual

Page: 99 / 214

AT-SBx908 GEN2 Installation Guide for Virtual Chassis Stacking
99
Installing Blank Line Card Slot Covers
After installing the Ethernet line cards, inspect slots 1 to 8 for empty slots.
Empty slots need to be covered with the blank slot covers that come with
the chassis. Do one of the following:

If there are no empty, uncovered line card slots, go to “Installing
the Blank Power Supply Slot Cover” on page 101.
 If there are empty, uncovered line card slots, perform the following
procedure.
To install blank slot covers, perform the following procedure:
1. Position the blank slot cover with the notch in the upper left and slide it
into the empty slot. Refer to Figure 54.
Figure 54. Installing a Blank Slot Cover
2. Tighten the two captive screws with a #2 Phillips-head screwdriver to
secure the cover to the chassis. Refer to Figure 55 on page 100.
Notch