Allied Telesis AT-AR3050S, Installation Manual

Page: 55 / 80

Installation Guide for AT-AR3050S, AT-AR4050S Routers
21
Installing the Router in an Equipment Rack
This procedure requires the following items:

Eight bracket screws (not provided)

Two equipment rack brackets (not provided)

Two handles (not provided)

Four handle screws (not provided)

Flat-head screwdriver (not provided)

Cross-head screwdriver (not provided)

Four standard equipment rack screws (not provided)
Note
Rack mount kits can be purchased separately from your Allied
Telesis dealer.
Note
You can mount two routers side-by-side in a drawable tray with the
AT-RKMT-J15 rack mount kit. The AT-RKMT-J15 rack mount kit can
be purchased separately from your Allied Telesis dealer.
Installation guidelines can be found in “Choosing a Site for the Routers” on
page 14. Here is the procedure for installing the routers in a 19-inch
equipment rack.
Caution
The chassis may be heavy and awkward to lift. Allied Telesis
recommends that you get assistance when mounting the chassis in
an equipment rack.
 E28
1. Place the unit upside down on a level, secure surface, as shown in
Figure 5.