Allied Telesis AT-2712FX, Installation And User Manual, Page: 29 / 100

Secure Ethernet Network Adapter Installation and User’s Guide
29
Installing a Network Adapter Card
The following instructions apply to installing the AT-2712FX/SC, AT-
2712LX20/SC, and AT-2912T adapters in most systems. For details about
performing these tasks on your particular system, refer to the manuals that
were supplied with your system.
Note
To perform this procedure, you need to provide one Phillips-head
screw.
To install an adapter, perform the following procedure:
1. Review the “Pre-Installation Checklist” on page 25 and “Reviewing
Safety Precautions” on page 22.
Before installing the adapter, ensure the system power is OFF and
unplugged from the power outlet, and that proper electrical grounding
procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover and select any appropriate empty PCI slot.
See Figure 9 on page 30.
If you do not know how to identify an appropriate PCI slot, refer to your
system documentation.