Allied Telesis AT-2701FTXa/SC, Installation & User Manual, Page: 55 / 94

AT-2701 Series Fast Ethernet Adapter Installation Guide
55
##############################
DEVICE="eth
x
"
NM_CONTROLLED="yes"
ONBOOT=yes
HWADDR=
xx:xx:xx:xx:xx:xx
TYPE=Ethernet
BOOTPROTO=dhcp
DEFROUTE=yes
PEERDNS=yes
PEERROUTES=yes
IPV4_FAILURE_FATAL=yes
IPV6INIT=no
NAME="auto eth
x
"
ETHTOOL_OPTS="autoneg off speed 100 duplex full"
##############################
Note
Replace
"eth
x
"
with the name of the Ethernet interface that you
obtained in step 2 and
xx:xx:xx:xx:xx:xx
with the hardware
address of your adapter.
"eth
x
"
appears twice in the file.
5. Save the
ifcfg-eth
x
file.
6. Repeat step 3 to 5 for all of the Ethernet interfaces of AT-2701 series
adapters on your system.
7. Reboot your Linux system.
8. Verify that your AT-2701 series adapter is running 100 Mbps in the full-
duplex mode by entering the following command:
ethtool eth
x
The command output should display:
Advertised Auto-Negotiation is No
Speed is 100
Duplex mode is Full
9. Repeat step 8 for all of the Ethernet interfaces of AT-2701 series
adapters on your system.