Allied Telesis 2911 Series, User Manual

Page: 35 / 122

AT-2911 Series Gigabit Ethernet Network Adapters Installation and User’s Guide
35
Installing the AT-2911 Series Adapter Card
The following instructions describe how to install an AT-2911 series
adapter in most systems. Refer to the manuals that were supplied with
your system for details about performing these tasks on your particular
system.
To install an AT-2911 series adapter, perform the following procedure:
1. Review “Reviewing Safety Precautions” on page 30 and
“Pre-Installation Checklist” on page 32.
Before installing the adapter, ensure the system power is OFF and
unplugged from the power outlet, and that proper electrical grounding
procedures have been followed.
Warning
To prevent electric shock, do not remove the cover. No
user-serviceable parts inside. This unit contains hazardous voltages
and should only be opened by a trained and qualified technician. To
avoid the possibility of electric shock, disconnect electric power to
the product before connecting or disconnecting the cables.
 E1
2. Remove the system cover. See Figure 12.
Figure 12. Removing the PC Cover
3. Select any appropriate empty PCIe slot.
If you do not know how to identify an appropriate PCIe slot, refer to
your system documentation.