16
Figure 10 - Troubleshooting Analysis Chart
PROBLEM
POSSIBLE CAUSE
CORRECTION
Hydraulic oil becomes too hot.
Winch has been operated in the
BRAKE-OFF
position for long
periods.
Use the
BRAKE-OFF
position less.
When the
BRAKE-OFF
position is used,
the hydraulic oil fl ows continuously
through the relief valve. See the Service
Manual
for additional troubleshooting.
Low oil level.
Add oil.
Extensive inching.
Allow time for oil to cool after inching.
Clogged suction strainer.
Check and clean or replace the suction
strainer.
Defective or improperly adjusted oil
relief valve.
See the Service Manual for additional
troubleshooting.
Brake begins to release before
clutch is applied.
Brake is worn or needs
adjustment.
See the Service Manual for additional
troubleshooting.
Pressure modulator needs repair
or adjustment.
Winch brake does not apply or
release correctly.
Brake is worn or needs
adjustment.
See the Service Manual for additional
troubleshooting.
Low oil pressure.
(continued on next page)
Summary of Contents for W8L
