Repairs
4 - 32
16. Install 1.75” (45 mm) long or longer capscrews into
holes with pins. (longer capscrews work better).
17. Place block underneath retainer so that pressure
plate is suspended in the air.
18. Alternately tighten capscrews to compress springs
until reaction plate rests on hub. While tightening,
align internal splines of friction stack with hub splines.
19. Align external splines/tabs of friction stack.
20. Apply HCE-67 threadlocker to six 1” (25 mm) long
capscrews.
21. Install & torque three of these shorter capscrews in
the open holes.
22. Alternately loosen the three longer capscrews &
remove them but leave the pins in place.
23. Install & torque the three remaining shorter
capscrews.
24. Check final height “D”. it should be +0.012/-0.000
of original height “D”.
- BRAKE-OFF Clutch Assembly
Summary of Contents for H6H
