37987
11
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
10. SLOW SPIN OR NO SPIN
11. CONSTANT SPIN
POSSIBLE CAUSE
TO CORRECT
Inoperative timer.
Test timer and replace if inoperative.
Loading door is open or door safety switch is
inoperative.
Close loading door, or test switch and replace if inoperative.
Bind in water pump.
Replace pump.
Loose or broken drive belt.
Replace belt.
Washer has gone out-of-balance.
Open loading door to reset out-of-balance switch.
Rearrange load in washtub.
Motor will not run.
Check motor and replace if inoperative.
Sheared motor pulley roll pin.
Remove drive motor and replace roll pin and any
other damaged parts.
Motor overload protector has cycled.
Wait two or three minutes for overload protector to reset. If
protector cycles repeatedly, refer to Paragraph 9.
No clearance or stuck brake pads.
Free sticky brake pads or replace pads.
Broken, loose, or incorrect wiring.
Refer to appropriate wiring diagram.
Inoperative transmission assembly.
Repair or replace the transmission assembly.
POSSIBLE CAUSE
TO CORRECT
Inoperative timer.
Test timer and replace if inoperative.
Washtub does not stop spinning within seven
seconds after loading door is opened.
Replace brake pads.
Excessive wear on brake pads, or missing
brake pads.
Replace brake pads.
Shorted or incorrect wiring.
Refer to appropriate wiring diagram.
