8
37987
Section 3 Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
3. NO WARM WATER
4. WATER FILL DOES NOT STOP AT PROPER LEVEL
5. TIMER DOES NOT ADVANCE
POSSIBLE CAUSE
TO CORRECT
No hot water.
No cold water.
Refer to Paragraph 2.
POSSIBLE CAUSE
TO CORRECT
Inoperative pressure switch.
Test switch and replace if inoperative.
Air leak in pressure hose.
Replace hose.
Sediment on or under mixing valve diaphragm,
defective diaphragm, or armature binding in
armature guide.
Disassemble and clean mixing valve, or replace
complete valve.
Broken, weak, or missing mixing valve armature
spring.
Disassembly valve and replace spring, or replace.
complete valve.
A siphoning action started in washer will cause
water to be siphoned from washer during cycle
due to end of drain hose being lower than
cabinet top of washer. Drain hose fits tight in
standpipe or drain.
Install No. 562P3 Siphon Break Kit. Provide an
air gap around drain hose and drain receptacle.
Water in pressure hose.
Blow air through hose to remove water.
Broken, loose, shorted, or incorrect wiring.
Refer to appropriate wiring diagram.
POSSIBLE CAUSE
TO CORRECT
Timer is designed to pause during fill periods.
Allow completion of fill period.
Inoperative timer.
Test timer, and replace if inoperative.
Loading door is open.
Close loading door. Loading door MUST be closed any time
the washer is set to fill, agitate or spin.
Washer will not fill.
Timer pauses until pressure switch is satisfied. Refer to
Paragraphs 1 and 2.
Timer motor lead wire off timer terminal.
Refer to appropriate wiring diagram and reattach wire.
Broken, loose or incorrect wiring.
Refer to appropriate wiring diagram.
Make sure washer isn’t siphoning during rinse in
cool down.
Install siphon break kit, Part No. 562P3.
