Alliance Laundry Systems ZFN50FSP111CW01, Troubleshooting Manual

Page: 39 / 44

802846
37
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 4
Adjustments
IMPORTANT: When reference is made to
directions (right or left) in this manual, it is from
operator’s position facing front of washer.
1 8 . Cabinet Leveling Legs
a. Place washer in position on a solid, sturdy and
level floor. Installing the washer on any type
of carpeting, soft tile, a platform, or other
weakly supported structures is not
recommended.
b. Place level on washer, refer to Figure 4 , and
check if washer is level from side to side and
front to back.
NOTE: Level must rest on raised portion of top
panel. Refer to
Figure 4 .
c. If washer is not level, tilt washer to access
front and rear leveling legs. For easier access
to leveling legs, prop up washer with wooden
block. Refer to
Figure 4 .
d. Loosen locknuts and adjust the leveling legs
until the washer is level from side to side and
front to back (using a level). Make sure
washer does not rock . Refer to Figure 4 .
e. Tighten the locknuts securely against the
washer base. If the locknuts are not tight,
washer will move out of position during
operation.
f. Place rubber feet on all four leveling legs.
Refer to Figure 4 .
g. Verify that washer doesn’t rock.
h. If unit vibrates or shakes during operation,
follow additional leveling procedure below. It
is especially effective if unit is installed on
uneven, non-concrete surface.
i. Loosen one front leveling leg locknut. Refer
to Figure 4 .
j. Run cycle with unbalanced load (single pair
of blue jeans or knotted towels).
k. During 1000 RPM spin, adjust leg up or down
by turning it 1/8 turn until washer’s vibration
is reduced and washer is at its most stable
point.
l. Re-tighten locknut.
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
DO NOT slide washer across floor if the
leveling legs have been extended, as legs
and base could become damaged.
W248
CAUTION
Use of the dispenser drawer or washer door
as a handle in the transportation of the
washer may cause damage to the dispenser
or door.
W185
CAUTION