Alliance Laundry Systems UF18PC, Operation/Programming Manual

Page: 25 / 74

23
Programming
F232061
Coin 1 Denomination
The display will read “Con1” for one second,
“dEno” for one second, then the coin 1
denomination. For example, if coin 1 is a
quarter, the display will read “25” for coin 1
denomination.
Press the Up key to increase the denomination,
or the Down key to decrease the denomination.
Coin 2 Denomination
The display will read “Con2” for one second,
“dEno” for one second, then the coin 2
denomination. For example, if coin 2 is a
quarter, the display will read “50” for coin 2
denomination.
Press the Up key to increase the denomination,
or the Down key to decrease the denomination.
Note:
The “Con2” setting has no effect on
models equipped with a single coin acceptor.
Cycle Count
To display the current cycle count, press the
Start key while the display is showing the
temperature in the sump. The display will
show a two-digit number indicating how many
cycles have been run to completion (cycles
which were stopped in progress are not
counted). Press the Start key to return to
program mode without resetting the count.
Press the Stop key to reset the count to zero
and return to program mode.
Cycle Programming
To edit an existing cycle or create a new cycle,
press the Up key while the display is showing
the temperature in the sump. The display will
show “CY01.” Press the Up or Down key
until the desired cycle number is displayed.
Press the Start key to begin editing the
selected cycle.
Segment Programming
All cycle programs (“CY1”–“CY16”) can be
customized within a preset program structure.
Each cycle program consists of eight program
segments. See the following table.
Cycle Program Segments
Segment Display Segment Display
Prewash PrE Fill 3 FIL 3
Wash UASH Fill 4 FIL 4
Fill 1 FIL 1 Fill 5 FIL 5
Fill 2 FIL 2 Fill 6 FIL 6