Alliance Laundry Systems UD08F055, Programming Manual, Page: 13 / 16

Programming Supplement
11
1300546 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Number of Resistor Groups
Installed
This option allows the owner to set the number of
heating resistor groups installed on the finisher.
NOTE: This parameter is only displayed if the
electrical heating type (EL) was selected for the
Heating Type option.
How to Program Number of Resistor Groups
Installed
1. Control must be in Programming Mode. Refer to
Entering Programming Mode section.
2. The current value is shown in the Temperature
Display, while “n” is shown on the Speed display.
Default value: 2
Available values: 1 or 2
3. Press the Increase Preset Temperature keypad (+)
or Decrease Preset Temperature keypad (–) to
change the set value.
4. Press Display Preset Temperature keypad (SET)
to confirm the current value and proceed to the
next parameter.
5. When pressing SET after setting last parameter
(Number of Resistor Groups Installed), the first
parameter (Temperature Measurement Unit) is
shown again.
NOTE: The setting of the last parameter is only
stored if you have confirmed it by pressing SET
before leaving the parameter setting mode.
How to Exit Programming Mode
To exit Programming Mode, press STOP keypad or
turn finisher off and on.