Installation
Before You Start
Tools
For most installations, the basic tools you will need are:
SWD1021N_SVG
11
10
9
8
4
3
2
1
6
7
5
1.
Wrench
2.
1/4 inch Driver
3.
Screwdriver
4.
Level
5.
Wood Block
6.
Pliers
7.
5/16 Inch Socket Wrench
8.
Gloves
9.
Teflon Tape (Gas Models)
10.
Duct Tape
11.
Safety Glasses
Figure 1
NOTE: If the unit is delivered on a cold day (below
freezing), or is stored in an unheated room or area dur-
ing the cold months, do not attempt to operate it until
the unit has had a chance to warm up.
NOTE: Some moisture in the wash drum is normal. Wa-
ter is used during testing at the manufacturer.
NOTE: This appliance is suitable for use in countries
having a warm, damp climate.
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
W299
Parts Included
An accessories bag has been shipped inside your unit. It includes:
• Product literature
• Three screws (electric dryers only)
• Two fill hoses with washers and filter screens
• Four rubber feet
• Beaded strap
• Two shipping hole plugs
Parts Needed
Two fill hoses are required for installation. Order 807239 Hose
Kit if needed. Kit includes two fill hoses color-coded for hot and
cold water.
If using any other hoses, follow these requirements:
• Hoses must be new.
• Hoses must be a minimum of 3/8 in. inside diameter. Smaller
inside diameter hoses will cause long fill times which could
create nuisance fill errors.
• The two plain rubber washers and two filter screens included
with the washer in the accessories bag must be installed in the
fill hose couplings. Refer to
screens help prevent foreign materials from clogging the wa-
ter mixing valve.
Removing Dryer
Use the following steps if the installation requires removal of the
dryer. Two people are required to perform this task.
1. Remove dryer front access panel.
2. Remove two screws holding control panel to control cabinet.
3. Remove two 7/16 inch screws and washers attaching dryer to
washer.
4. Tip dryer back and disconnect dryer control wire harness
from main dryer wire harness.
5. Slide dryer forward until rear leveling legs slide into notches
in the control cabinet.
6. Lift dryer and place it on a level surface.
Reassembling Dryer
Installation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
9
Part No. 807638EN
Summary of Contents for Speed Queen SF7003WE
Page 2: ......
