© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
67
F232204R5
18. Replacing Old-Style Tension Spring on Electronic Coin Drop
If coin drop is not accepting coins, perform the
following:
1. Clean coin drop according to instructions
supplied with drop.
2. On electronic coin drops with an old-style
), test and replace tension spring using the
following instructions.
Remove Coin Drop From Machine
1. Disconnect electrical power to machine and drop.
2. Remove coin drop from machine.
Test Tension Spring
1. Push coin return button to open and close coin
drop cover to clear possible coin jams. Refer to
.
2. Manually hold down coin drop cover and insert
coin. Refer to
3. If coin drop now operates properly, replace
tension spring using instructions on following
pages.
Replace Tension Spring
1. Move tension spring downward until cover catch
is free. Refer to
2. Open cover for coin drop.
3. Place a small flathead screwdriver under right
side of tension spring and lift up. Refer to
4. Use screwdriver to move spring approximately
3 mm to left.
5. Lift spring over left tab. Refer to
Figure 11
Figure 12
MIX7B
Coin Drop
Cover
Coin Return
Button
Tension
Spring
MIX6B
Coin Drop
Cover
Figure 13
Figure 14
DRY2088N
Cover Catch
Tension
Spring
MIX2B
Small Flathead
Screwdriver
Right Side of
Tension Spring
Left Tab
www.groupdynamics-laundry.com