48
800793
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
28. CABINET TOP ASSEMBLY – MODEL
LTS85A*H
NOTE: Front edge of cabinet top is held in place by
two spring clips located on top flange of front panel.
Refer to Figure 10.
a. Insert putty knife between cabinet top and top
edge of front panel (approximately three inches
in from side). Refer to Figure 10.
b. Push in on putty knife and at the same time lift
front edge of cabinet top. Repeat for opposite
side.
c. If area or space permits, lift cabinet top to a
vertical position.
NOTE: To avoid damage to hinges, be sure to
support top with a chain (not included) or
equivalent. Refer to Figure 11.
TO REMOVE CABINET TOP FROM
WASHER
NOTE: Front edge of cabinet top is held in place by
two spring clips located on top flange of front panel.
Refer to Figure 10.
d. Insert putty knife between cabinet top and top
edge of front panel (approximately three inches
in from side). Refer to Figure 10.
e. Push in on putty knife and at the same time pull
top edge of front panel away from front of
washer. Repeat for opposite side.
f. Remove three screws holding hood assembly to
control hood rear panel. Refer to Figure 5.
g. Pivot hood assembly forward on cabinet top.
Refer to Figure 5.
h. Disconnect hose from pressure switch and push
hose down through hole in cabinet top.
i. Disconnect wire harness at disconnect blocks,
power cord, motor harness wires and ground
wire from relay and control board.
j. Reinstall control hood assembly.
k. Lift front of cabinet top slightly and pull
forward to disengage from rear hold down
brackets.
l. Carefully lift cabinet top off washer and set
alongside the washer cabinet on protective
padding.
29. CABINET TOP ASSEMBLY – ALL OTHER
MODELS
a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel. Refer to Figure 9.
b. Gently lower the access panel to disengage
panel locators from bottom edge of front panel.
c. Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 12.
d. Remove two screws on top right side of front
panel (above dispenser drawer), top left two
screws and then bottom two front corner
screws. Refer to Figure 13.
e. Unplug wire harness from both the door latch
switch and from the door switch. Refer to
Figure 16. Remove clips holding wire harness
and door seal hose along top flange of front
panel and remove front panel.
NOTE: Door seal hose and wire harness must be
reinstalled in the appropriate clips and holes along
top flange of front panel. Refer to Figure 16.
f. Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 14.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to the right or left of spring.
g. Grasp loading door seal lip. Refer to Figure 15,
Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
h. Using a circular motion, pull seal up
(Figure 15, Step 1), out (Figure 15, Step 2) and
down (Figure 15, Step 3).
