Alliance Laundry Systems IYG065J, Original Instructions Manual

Page: 79 / 106

NOTE: The error message "Too Hot" can also appear at
the end of a cycle even if no failure has occurred as an
example, suppose a wash program with a hot wash. Af-
ter this hot wash sequence, no sequence with a low
water temperature has been programmed. At the end of
such a wash cycle, the temperature in the tub will stay
high even if there is no water in the tub. As a result the
wash computer will decide that it’s not safe to open the
door as the measured temperature inside the tub is too
high. Without inserting cold water inside the tub, it can
take a long time before the temperature drops to an ac-
ceptable safe level. Once the temperature in the drum
has dropped sufficiently, the failure message will dis-
appear and the door will be unlocked automatically.
DEPENDING ON THE FAILURE TYPE THE COMPUTER
WILL START A SPECIFIC PROCEDURE:
WHEN SAFETY IS INVOLVED
• Full stop + tumble: the program is stopped but will run the
tumble sequence.
• Full stop + safety time: the program is stopped and a safety
time is started.
• Don’t start: the program will not be started as long as the safe-
ty conditions are not fulfilled.
WHEN SAFETY IS NOT INVOLVED
• Full stop + request for continue: a request to "Continue ?" the
program is displayed.
• Skip + continue: the actual cycle step is skipped and the pro-
gram continues with the next step.
• Continue: the program continues.
SPECIAL CASES:
Fault 11: Fill Time Failure and Fault 14: Heating Time Failure:
• After overruling and erasing the failure message, you can re-
start or stop the sequence, as Continue ? will be displayed.
Possible cause:
• Water supply inlets closed.
• Decreasing capacity of the heating elements.
Fault 31: Initialization Fault Inverter and Fault 32: Verification
Fault Inverter:
• Indicate that the frequency inverter is not loaded with the cor-
rect parameter settings, the washing machine can be damaged
when the inverter is functioning with the wrong settings. Do
not use the washing machine before a technician has inspect-
ed the problem.
Fault 41: Service Due:
• Will occur over and over again until you have reset the cycle
counter. Refer to Service Menu as to how to reset the cycle
counter.
Failure Message Overview
Failure Message Overview
Num-
ber
Failure Mes-
sage Failure Action Fault Occurrence
E2 No Drain Drain failure Full Stop + tumble Draining sequence
E3 Tilt Fault Safety switch activated Full stop + tumble Whole cycle, revolutions under
the distribution revolutions lev-
el.
E4 Imbalance Safety switch activated during
the transition from distribution
into spin sequence. Skip + continue Spin
E5 Tilt High Sp Out of balance : high spin Full stop + safety time >500 or 750 RPM
E6 Door Switch Door switch failure Full stop + safety time Whole cycle
E7 Door Coil Door lock failure Full stop + safety time Whole cycle
E8 Door Closed Start Door close check at start failure Don’t start At start up
E9 Door Unload Door lock switch closed failure Don’t start End cycle
Table 47 continues...
Troubleshooting
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
79 Part No. D1631ENR7