Alliance Laundry Systems HTE517, Programming Manual

Page: 13 / 79

800000
11
Section IV
Washer Operation
Start Up
When power is applied to the washer, the control will
display PRICE, INSERT COINS, the decimal point,
and the vend price. The PRICE and INSERT COINS
light will remain lit until the vend price has been
satisfied. The default cycle setting is PERM PRESS,
the wash water fill temperature is WARM, and the
rinse water temperature is COLD. The LED’s will
flash on PERM PRESS and will be lit on WARM at
the start of the cycle. See Figure 2. These default
settings are owner programmable. Refer to Section
VIII.
Default Mode
When using the cycle settings, the user must either
press NORMAL, PERM PRESS or DELICATES.
PERM PRESS, if it is the default cycle, will need to be
selected once. When choosing NORMAL or
DELICATES, the user must press the respective
keypads once, the LED will blink, and the user must
then press appropriate keypad again.
The user will be able to select a different cycle or wash
water temperature by pressing a cycle pad when the
machine is in the default mode or in the first fill cycle.
If not enough coins are entered to satisfy the vend
price, the control will display the remaining vend price
needed to start the cycle. If the first fill was interrupted
to change the temperature (which requires more
money), and the vend price is not satisfied within one
minute, the washer control will go back to the first
selection and the cycle will restart from the point it
was stopped. After the first fill, all key presses will be
ignored, allowing the washer to go through the
complete cycle.
When a cycle is complete, the control will display
TIME REMAINING,
“00” until the washer door is
opened, a key is pressed, or a coin is entered. When
one of these three options occur, the display will revert
back to the default mode. See Figure 2.
Cycle Sequence
Upon the start of a cycle, the Electronic Control will
display TIME REMAINING and the total cycle time
including one (1) minute of fill time. The appropriate
status words will light while the machine passes
through different cycle steps. Any coin entered after
the first fill cycle will be added to the total coin
counter, but user will not be able to change cycles or
water temperature.
Closing Washer Door
If the door is not closed when the START pad is
pressed,
“d:or”
will be displayed and will flash one (1)
second on and one (1) second off until the door is
closed. Once door is closed, the START pad must be
pressed again to lock door and start cycle. If the door
does not lock within 15 seconds of being closed,
“E:dl”
will be displayed indicating a door lock error and
machine will shut off.
Signals
There are three options when a signal can be used
during the washer operation. The owner may program
when the signal will sound and at what volume level.
These three options are listed below:
1. End of Cycle Signal
By default, this signal is turned off. If turned on, the
signal sounds for three (3) seconds at the end of a
cycle, at one of the three programmable volume
levels (High Medium or Low).
2. Signal On Keypad Depression
By default, this signal is set at the lowest volume
level, and sounds for a quarter of a second each
time a keypad is pressed. This signal can be
programmed at one of three volume levels (High
Medium or Low).
3. Signal On Coin Drop
By default, this signal is turned off. If turned on,
this signal will sound for a quarter of a second each
time a coin is entered at one of the three
programmable volume levels (High Medium or
Low).
Figure 2
WASH
RINSE SOAK SPIN
PRICE TIME REMAINING
INSERT COINS UNBALANCE
FABRICS AND TEMPERATURES
NORMAL
HOT
PERM
PRESS
WARM
DELICATES
COLD
C742IE3A