Alliance Laundry Systems HC18, Preliminary Service Manual

Page: 15 / 31

F238000
15
Section 4 Service Procedures
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer-extractor before servicing.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W171
WARNING
20. GRAPHIC PANEL OVERLAY
NOTE: The graphic panel overlay has an adhesive
backing. Using a hair dryer to heat up adhesive will
make it easier to pull off overlay.
a. Remove adhesive overlay by peeling it from
front channel.
Installing Graphic Panel Overlay
IMPORTANT: Use denatured alcohol to clean
residue from front channel before applying new
decal.
NOTE: Before removing protective backing from
new overlay, check fit of overlay to front channel.
Indicator light holes and selector switch holes are
the locating guides.
a. Once panel overlay is fitted to front channel,
carefully peel protective backing from right end
of panel overlay and press in place.
b. Remove rest of the protective backing from
panel overlay and press overlay into place.
21. TIMER AND SELECTOR SWITCH
BRACKET
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
Figure 1 . Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
b. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
IMPORTANT: When replacing the timer and
selector switch assembly, do a wire-for-wire
exchange, or write down all the wire terminal
connections before removing any wires. If you have
a problem, refer to the wiring diagram on the
underside of the cabinet top.
c. Remove four nuts holding timer and bracket to
front of control panel, refer to Figure 4 .
d. Remove timer and selector switch bracket as far
as wires permit.
Figure 4
B004SE1A
SELECTOR
SWITCH
BRACKET
SELECTOR
SWITCH
TIMER