Alliance Laundry Systems HC18, Preliminary Service Manual

Page: 13 / 31

F238000
13
To reduce the risk of electrical shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer-extractor before servicing.
• Never start the washer-extractor with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer-extractor is properly grounded.
W171
WARNING
Section 4
Service Procedures
16. CABINET TOP
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
Figure 1 . Lift cabinet top off machine and set
aside.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
17. CONTROL MODULE BOX COVER
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
Figure 1 . Lift cabinet top off machine and set
aside.
NOTE: When reinstalling cabinet top, metal edges
on the dispenser opening must be fitted inside of
dispenser.
b. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
18. COIN DROP
a. Insert key into cabinet top lock and turn
clockwise. Lift up on front of cabinet top until
it is just past the rear hinges, or 90 degrees, refer
to
Figure 1 . Lift cabinet top off machine and set
out of way.
NOTE: When reinstalling cabinet top, metal edges
on dispenser opening must be fitted inside of
dispenser.
b. Remove two T20 Torx head screws from
control module box cover. Lift up cover and set
aside.
c. Loosen screw holding coin drop to backside of
control panel.
d. Remove screw in middle of coin drop.
e. Disconnect red three-wire harness from power
supply board. Remove wires from coin
blocking solenoid, refer to
Figure 2 .
f. Remove coin drop and set aside.
Figure 1
B001SE1A
METAL EDGES
OF DISPENSER
OPENING
HINGE