-15-
802716
DRY2024N
Maintenance
Lubrication
All moving parts are sealed in a permanent supply
of lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.
Care of Your Dryer
Dryer Interior
Wipe the surfaces using a soft cloth and
household cleaner or a non-abrasive paste of
powdered laundry detergent and hot water,
followed by a short heat cycle with a load of rags.
To remove crayon or ball point ink off the dryer
drum, put the heat on high and use old rags in the
dryer to absorb the crayon or ink. If unsuccessful,
contact the appliance dealer. DO NOT use any
chemicals in the dryer.
IMPORTANT: The use of chlorine bleach for
removing any discolorations should be avoided
because bleach could damage the finish.
Cabinet
Wipe the dryer cabinet as needed. If detergent,
bleach or other washing products have been
spilled on the dryer, wipe immediately. Some
products will cause permanent damage if spilled
on the cabinet.
Control Panel
Use only a damp or sudsy cloth for cleaning the
control panel. Some spray pretreat products may
harm the finish on the control panel.
NOTE: The wiring diagram is located inside the
control panel.
Exhaust System
The exhaust duct should be inspected after one
year of use and cleaned if necessary. Inspect and
clean exhaust duct every one to two years as
required thereafter.
The weather hood should be checked frequently to
make sure the dampers move freely, dampers are
not pushed in and that nothing has been set
against them.
Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors
and liquids.
Do not obstruct the flow of combustion and
ventilation air.
NOTE: Verify proper operation after servicing.
Motor Overload Protector
The dryer’s motor overload protector stops the
motor automatically in the event of an overload.
After cooling, the overload protector will reset
itself. Dryer can be restarted by pushing the
timer knob in. If overload protector cycles again,
remove the dryer from use and call the service
person to correct the problem.
To reduce the risk of an electric shock,
serious injury or death, disconnect the
electrical service to the dryer before
cleaning the interior.
W132
WA R N I N G
To reduce the risk of electric shock,
disconnect the electrical service to the
dryer before cleaning.
W043
WA R N I N G
