Alliance Laundry Systems CP040PHN1, Programming

Page: 26 / 60

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
F8112301R3 24
Changing To Another Program
For the first 3 minutes after machine has started, it is
possible to change the selected program to a different
program.
1. To change to a different program simply input
program number to change.
2. The display will now show “ P.xx.StArt ” (P.xx
indicates new program number).
3. If this is correct program number, press Enter.
Temporary Program Alteration
1. Select a program number.
2. Before starting program, press and hold
Temperature button.
3. While holding Temperature button in, press
Enter.
4. Scroll through each program step using Enter
button and make desired changes.
5. When finished, press Start to begin program. The
program will now run with temporary alterations.
Temperature and RPM Display
By pressing Temperature button on keypad one time
while program is in operation, the current temperature
will be displayed.
Press Temperature button again and programmed
temperature will be displayed momentarily.
Press Temperature button again and highest
programmed temperature of program will be displayed
momentarily.
Press Temperature button again and cylinder speed
will be displayed momentarily.
By pressing and holding Temperature button for 3
seconds during any of the above, display will remain
at that function until Temperature button is pressed
again.
Rapid Advance
Pushing and holding Enter button on keypad can rapid
advance a program through each program step. Rapid
Advance will stop at each drain step and Enter button
must be released and pressed again in order to
continue with Rapid Advance sequence.
Rapid Advance feature may be disabled by selecting
“ no ACCL ” in Setup (Pre-Program) Mode. Refer to
Setup (Pre-Program) Mode section.
Programmed Stop
If an indefinite time stop (0 minutes) was
programmed, the program will pause and wait for
operator to restart program. Water will stay in machine
and all cylinder movement will cease. Display will
show “ StoP ”. Program will not continue until Start
button is pressed.
If a programmed time stop was programmed (1-999
minutes), display will alternate between “ StoPtinE ”
and remainder of programmed stop time. Time stop
can also be interrupted by pressing Start button.
NOTE: If a signal has been programmed, it will
sound at beginning of “ Programmed Stop Time ”.
If a stop was programmed during “ Final Spin/
Extract ”, program will automatically resume after
20 minutes.
Stopping a Program
1. To terminate a program, press Stop button on
keypad.
2. After 5 seconds machine will drain water and
“ oPEn door ” will appear on display after
approximately 30 seconds.
3. Open door and “ CLoSE ” will appear on display.
4. Close door and display will flash program and
time information where it was stopped.
5. Cycle may be resumed after closing door and
pressing Start or stopped by pressing Stop button.
6. Press Stop button and display will show “ StoP ”
and “ PXX End ”.
7. Open door and display will return to “ StArt ”.
Stop button may be disabled by selecting “ no EnEr ”
in Setup (Pre-Program) Mode. Refer to Setup
(Pre-Program) Mode section.
www.groupdynamics-laundry.com
sales@groupdynamics.lv