Alliance Laundry Systems AT0350SRG, Service Manual

Page: 26 / 60

24
70143101
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the tumbler before servicing.
• Close gas shut-off valve to gas tumbler before servicing.
• Close steam valve to steam tumbler before servicing.
• Never start the tumbler with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the tumbler is properly grounded.
W002
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
22. LINT DRAWER/PANEL SWITCH
Refer to Figure 11 .
STACKED TUMBLE DRYER
a. Unlock and remove lint drawer. Refer to
Paragraph 19 .
b. Unlock and remove left control.
c. Disconnect harnesses.
d. Remove four screws holding plate at rear of
control box. Refer to Figure 7 .
e. Reach in through left control opening and
disconnect wires from lint drawer switch
terminal.
f. Compress locking tabs on top and bottom of
switch. Push switch through into lint drawer
opening.
NOTE: When installing switch, switch lever must
point toward rear of tumble dryer.
STAND ALONE TUMBLE DRYER
Refer to Figure 12 .
a. Remove front panel. Refer to Figure 3 .
b. Disconnect wires from lint panel switch.
c. Remove two screws holding switch to switch
mounting bracket.
Figure 10
LINT
DRAWER
SEAL
TMB1756S
Figure 11
Figure 12
T303SE1A
LINT
DRAWER
SWITCH
LINT
DRAWER
OPENING
LOCKING TAB
REACH IN
THROUGH THIS
OPENING
REAR VIEW
OF SWITCH
25 C STA RT
HIG
H TE MP
ME D
TE MP
LO W
TE MP
NO HE
AT
1
2
3
SE
LE CT TE MP
INS ER T CO
IN
PU SH
ST AR T
T311SE1A
LINT
PANEL
SWITCH
SWITCH
MOUNTING
BRACKET
SCREW