© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
39
802957
Maintenance
User-Maintenance Instructions
Lubrication
All moving parts are sealed in a permanent supply of
lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.
Cold Weather Care
If the unit is delivered on a cold day (below freezing),
or is stored in an unheated room or area during the
cold months, do not attempt to operate it until the
washer has had a chance to warm up.
Vacations and Extended Non-Use
IMPORTANT: To avoid possible property damage
due to flooding, turn off the water supply to the
washer whenever there will be an extended period
of non-use.
Leave the loading door open during extended periods
of non-use to allow the wash drum to dry out and
avoid a musty smell.
Care of Your Washer
Use only a damp or sudsy cloth for cleaning the
control panel. Some cleaning product sprays may
harm the finish on the control panel or damage the
interior.
Wipe the washer cabinet as needed. If detergent,
bleach or other washing products are spilled on the
cabinet, wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.
Do not use scouring pads or abrasive cleansers.
The wash drum will need no particular care although it
may need rinsing or wiping after an unusual load has
been washed.
The outside of the door window can be cleaned with
household window cleaner.
Running an occasional rinse cycle with bleach will
help to avoid a musty smell in the wash drum.
Cleaning Glass Sealing Area
In order to assure that the door properly seals against
water leaks, the following surfaces should be wiped
off periodically:
The outside perimeter of the door glass where the
seal contacts the glass.
The front surface of the door seal lip.
Usually a mild soap solution will work. If there is an
extreme build-up of minerals from a hard water
supply, the surfaces may need to be cleaned with a
lime removal chemical.
Replacing Hoses
Hoses and other natural rubber parts deteriorate after
extended use. Hoses may develop cracks, blisters or
material wear from the temperature and constant high
pressure they are subjected to.
All hoses should be checked on a monthly basis for
any visible signs of deterioration. Any hose showing
the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
Cleaning Foreign Object Trap
The washer’s pump has a trap that may collect foreign
objects. The trap may need to be cleaned if water is
draining slower than usual. To clean:
Disconnect washer from electrical supply.
While supporting the front access panel, remove
two screws from the bottom edge of the panel.
Gently lower the panel to remove it from the
washer.
NOTE: The pump may have some water in it. Use a
rag or a container to catch water. If the wash drum
is full of water, use a wet/dry shop vacuum to catch
the water.
With rag or vacuum ready, unscrew the cap on
the left side of the pump and remove trap.
Clean the debris from the trap.
Reinstall the trap and access panel.
Reconnect washer to electrical supply.
Filter Screen
Check the filter screens in the fill hoses for debris or
damage annually. Clean or replace them if necessary.
If the washer is filling with water slower than normal,
check the filter screens. Clean or replace them if
necessary.
Order filter screen Part No. F270300 from the nearest
authorized parts distributor.
