Allen Engineering Corporation RS832, Operations & Parts Manual

Page: 38 / 104

056840 - 10/2012
SECTION 2
OPERATIONS
Page 2-12
2.5 Operating
1. Fully engage the operator end directional drive tube control levers in the forward
direction.
2. Move the drive tube speed control lever slightly forward(a few rpm’s) and verify
that both drive tubes rotate.
3. Fully engage the operator end directional drive tube control lever in the reverse
(pull back) direction.
4. Return operator end directional drive tube control lever to center position.
5. Move the power unit end directional drive tube control lever fully forward and
verify that both drive tubes rotate.
6. Next, fully engage the power unit end drive tube control lever in the reverse (pull
back) direction and verify that both drive tubes rotate.
7. Return power unit end directional drive tube control lever to center position
8. Place the drive tube speed control lever in the straight up position (off).
9. Move the strike tube speed and direction control lever slightly forward. Verify
strike tube rotates in a clockwise rotation. Move lever slightly backwards and verify
that strike tube rotates in a counter-clockwise direction.
10. The Roller Screed is now ready for use.