Allen-Bradley The PowerFlex 755 On-Machine, User Manual

Page: 163 / 218

Rockwell Automation Publication 750-UM006C-EN-P - March 2022 163
Drive Maintenance Chapter 5
Replace the EMC Kit (1CH030) Follow the procedure to Remove Power on page 146 and follow the
instructions to Remove the Front Cover on page 148 . For information on how
to repair or replace the EMC kit (cat. no. 20-750-EMC1-F2) that is part of the
drive, see PowerFlex 750-Series EMC Plate and Cores - Frames 1...7,
publication
750-IN006 . After the EMC kit is replaced, follow the instructions
to Attach the Front Cover on page 169 . and to Apply Power on page 170 .
Replace the ETAP Module
(6ET210) 1. Follow the procedure to Remove Power on page 146
2. Follow the instructions to Remove the Front Cover on page 148 .
3. Use a flathead screwdriver to disconnect the wires listed in the
following table.
4. Disconnect the Ethernet cables.
5. Follow instructions in Ethernet Tap, publication 1783-PC011 to install
the new ETAP module.
6. Use a flathead screwdriver to attach the wires from step 3 to the
terminals.
7. Follow the instructions to Attach the Front Cover on page 169 .
For information on how to configure the ETAP (cat. no. 1783-ETAP), see
EtherNet/IP Network Configuration, publication
ENET-UM006 .
Wire Description Terminal Number
6ET210 –0V –
24V +
ETH1 1 (front)
ETH2 2 (rear)
ENET_DRIVE Device port on front panel
3-port EtherNet/IP Tap
Cat. No. 1783-ETAP
IEC Terminal Block
Cat. No. 1492-LD4
IEC End Barrier
Cat. No. 1492-EBLD4
IEC End Anchor