PowerFlex 700L Frames 2, 3A, and 3B Liquid-Cooled AC Drives User Manual
Chapter
3
Frame 3A and 3B Installation
Because most start-up difficulties are the result of incorrect wiring, take
every precaution to verify that the wiring is completed as instructed. Read
and understand all items before beginning actual installation.
Drive Components
Frame 3A and 3B complete drives are comprised of an Input Filter Bay and a
Power Module Bay. For Frame 3A drives, the Power Module Bay contains a
combined Converter/Inverter Power Module. For Frame 3B drives, the
Power Module Bay contains separate Converter and Inverter Power Modules.
Total Area Required for Drive Installation
Overall drive dimensions are shown in
Figure 3.1
as an aid in calculating
the total area required for installing Frame 3A and 3B drives.
Topic
Page
Removing the Power Module Covers
Removing the Active Converter Power Module Control Cassette
Removing the Inverter Power Module Control Cassette
Verifying the Drive’s Watts Loss Rating
Determining Wire Routing for Control, Ground, Drive Input, and Motor Output
Ungrounded or Resistive Grounded Installations
Installing Output Power Wiring
Installing Control Wiring from the Input Filter Bay to the Power Module Bay
Synchronization Connections for Frame 3A
Synchronization Connections for Frame 3B
DPI Connections for Frame 3A and 3B Drives
!
ATTENTION:
The following information is merely a guide for
proper installation. Rockwell Automation does not assume
responsibility or liability for the compliance or noncompliance to
any code, national, local or otherwise for the proper installation
of this drive or associated equipment. A hazard of personal injury
and/or equipment damage exists if codes are ignored during
installation.
Aotewell Ltd
www.aotewell.com
Industry Automation
HongKong|UK|China
+86-755-8660-6182