8
POINT I/O EtherNet/IP Adapter
Publication 1734-IN590A-EN-P - March 2003
Installing a Replacement EtherNet/IP Adapter to an Existing System
1.
Remove the existing adapter from the DIN rail as follows:
a. Disconnect the EtherNet connector from the adapter.
b. Pull up on the RTB removal handle to remove the terminal block.
c. Remove the adjacent module from its base.
d. Use a small bladed screwdriver to rotate the DIN rail locking
screw to a vertical position. This releases the locking mechanism.
e. Lift straight up to remove.
2.
Slide the safety end cap up to remove. This exposes the backplane and
power connections.
3.
Position the replacement adapter vertically above the DIN rail. (Make
certain the DIN rail lock is in the horizontal position.) Slide the
adapter down, allowing the interlocking side pieces to engage the
adjacent module.
4.
Press firmly to seat the adapter on the DIN rail. The adapter locking
mechanism will snap into place.
5.
Set the node address on the node address thumbwheel.
6.
Insert the end of the terminal block (RTB) opposite the handle into
the base unit. This end has a curved section that engages with the
wiring base.
7.
Rotate the terminal block into the wiring base until it locks itself into
place.
8.
Replace the adjacent module in its base.
9.
Reconnect the Ethernet cable to the adapter.
ATTENTION
!
You must use Series C POINT I/O modules with the
1734-AENT adapter. Series A or B POINT I/O modules
will not work with this adapter.