MicroLogix™ 1762-IQ8 DC Input Module
13
1762-IN004A-US-P
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or
non-hazardous locations only. The following ATTENTION statement applies to
use in hazardous locations.
!
ATTENTION: EXPLOSION HAZARD
•
Substitution of components may impair suitability for Class I,
Division 2.
•
Do not replace components or disconnect equipment unless
power has been switched off.
•
Do not connect or disconnect components unless power has
been switched off.
•
This product must be installed in an enclosure.
•
In Class I, Division 2 applications, the bus connector must be
fully seated and the bus connector cover must be snapped in
place.
•
In Class I, Division 2 applications, all modules must be
mounted in direct contact with each other as shown on page 6.
If DIN rail mounting is used, an end stop must be installed
ahead of the controller and after the last 1762 I/O module.