8 DeviceNet Digital Base Terminal Block CompactBlock LDX I/O
Publication 1790-IN012C-EN-P - January 2015
Mount on a Panel
For panel mounting, use these steps.
1.
Place the block against the panel where you want it mounted.
2.
Gently pull and position the expansion cover to the left.
3.
Place a center punch, nail, or similar device through the mounting holes in the
block and make two marks on the panel at the lower-left and upper-right corners
of the module.
4.
Remove the block and drill two holes in the panel to accommodate each of the
mounting screws.
5.
Replace the block on the panel and place a screw through each of the two
mounting holes.
6.
Tighten the screws until the block is firmly in place.
Mount on DIN Rail
For DIN-rail mounting, use these steps.
1.
Hook the top slot of the base block over the DIN rail.
2.
Pull down on the locking lever while pressing the base block against the rail.
3.
Push up on the locking lever to secure the base block to the rail when the base
block is flush against the rail.
44253
Locking Lever