POINT I/O Protected Output Module
7
Publication 1734-IN586B-EN-P - March 2002
3.
Insert the module straight down into the mounting base and
press to secure. The module will lock into place.
Installing the Removable Terminal Block (RTB)
A removable terminal block is supplied with your wiring base
assembly. To remove, pull up on the RTB handle. This allows the
mounting base to be removed and replaced as necessary without
removing any of the wiring. To reinsert the removable terminal block,
proceed as follows.
1.
Insert the end opposite the handle into the base unit. This end
has a curved section that engages with the wiring base.
2.
Rotate the terminal block into the wiring base until it locks
itself in place.
3.
If an I/O module is installed, snap the RTB handle into place
on the module.
WARNING
!
When you connect or disconnect the Removable
Terminal Block (RTB) with field side power
applied, an electrical arc can occur. This could
cause an explosion in hazardous location
installations.
Be sure that power is removed or the area is
nonhazardous before proceeding.