Compact 1769-ASCII Module
9
Publication
1769-IN068B-EN-P - May 2005
Panel Mount
Mount the module to a panel by using two screws per module. Use M4 or #8
panhead screws. Mounting screws are required on every module.
Panel Mount Procedure With the Dimensional Template
Panel Mount Procedure With Modules as a Template
The following procedure lets you use the assembled modules as a template for
drilling holes in the panel. Due to module mounting hole tolerance, it is
important to follow these procedures.
1.
On a clean work surface, assemble no more than three modules.
2.
Using the assembled modules as a template, carefully mark the center
of all module-mounting holes on the panel.
3.
Return the assembled modules to the clean work surface, including
any previously mounted modules.
4.
Drill and tap the mounting holes for the recommended M4 or #8
screw.
Host Controller
Compact I/O
Compact I/O
Compact I/O
Right End Cap
NOTE: All dimensions
are in mm (inches). Hole
spacing tolerance:
±0.4 mm (0.016 in.)
For more than 2 modules: (number of modules - 1) X 35 mm (1.38 in.)
Refer to host controller documentation for this dimension.
132
(5.197)
122.6±0.2
(4.826±0.008)
35
(1.38)
28.5
(1.12)